2016 Toyota Camry

Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection in Frontal Impacts. The front passenger seat's occupant classification system (OCS) may not have been calibrated properly during the manufacturing process. This could result in the non-deployment of the front passenger air bag and the front passenger knee airbag, which would increase the risk of injury to the seat occupant in a crash where airbag deployment is warranted. Correction: Dealers will re-calibrate the occupant classification system.

On certain vehicles, the tripod joint of the front drive shaft may have been improperly assembled. This could result in the snap ring that holds the tripod joint to dislocate, which could result in vibration and possible separation of the tripod joint, causing a loss of propulsion while driving and an inoperative transmission park system. The loss of propulsion could increase the risk of a crash. Additionally, if the driver exits the vehicle without applying the parking brake, the vehicle could roll away with the transmission in Park, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will check the serial number of the drive shafts, and replace as necessary.

On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation.

Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.